Frozen tirz chunk or air bubble stuck to vial wall?

[iwillloseweight]

I just mixed up a fresh T30 vial. It had been stored in the freezer before I reconstituted it. Now there’s something clinging to the inside of the vial, so I’d appreciate anyone telling me whether it’s still safe to inject!

 

[sheilarae74]

To me, that really comes across as bubbles. I'd give the vial a gentle swirl, then leave it alone for a bit and check whether it clears up.

 

[Yamfer2026]

I'd bring it up to room temperature and swirl it lightly. Apart from that, it seems fine.

 

[hazefred]

Sure, give it 1 or 2 days; should it still not break down, discard it

a gentle swirl could do the trick

 

[Riviera]

Give it a good shake and it ought to vanish. There's no harm in shaking...that's just an old wives' tale.

 

[BNLFL]

I would give it a shake as well.

 

[PopTart]

Those look like air bubbles to me. When I reconstitute, I vent the vials so the vacuum is released, and that gets rid of any bubbles.

 

[Jimothy82]

iwillloseweight said:


i just reconstituted a new vial of T30. i had this in the freezer and then reconstituted. there’s smth on the side of the vial so if anyone can let me know if it’s still good to pin thatd be appreciated!

Click to expand...

With a reta pen cartridge that I had reconstituted and filtered, I ran into a comparable situation. The side had these incredibly persistent little bubbles clinging to it, so I put it in the fridge for 2 days and they were gone. I pinned it on Monday and up to now everything seems fine?